Báng súng Fancy cho Smiley Blaster

It's a stock for smiley.

Based off some fancy shotgun stock.

Looks expensive or something.

“is there a pcar in your stock?”

Uses 3 20mm and 4 35mm #6 screws (the same ones used for the rest of the blaster). To assemble first screw together the core, outer shroud, and cheek pad, then slide on the inner shroud, butt plate and pad.

Print settings are whatever, just make sure the core has plenty of walls/tops/bottoms since it's the main structural element. I recommend printing the outer shroud with the front side facing down and a bit of support on the curved bit at the bottom. Also probably use brim for outer and inner shroud and the cheekrest.