Nắp đậy vỏ Raspberry Pi 4 cho NVMe HAT

A 3D-printed replacement cover for one half of the Geekworm Raspberry Pi 4 aluminum case that provides the extra clearance needed to fit a GeeekPi M.2 NVMe HAT on top of the Pi.

The Geekworm case is a two-piece aluminum shell. This printed cover replaces one side, while the other aluminum half is kept for heat dissipation. The result is an enclosed setup with NVMe storage and passive cooling.

All ports remain fully accessible (USB, Ethernet, HDMI, power, audio jack).

Designed in FreeCAD — source file included if you want to adapt it for a different HAT or case variant.

Designed for

• Case: Geekworm Raspberry Pi 4 Model B Aluminum Case

• NVMe HAT: GeeekPi M.2 NVMe HAT for Raspberry Pi 4

• Board: Raspberry Pi 4 Model B

Print Settings

• Material: PC (PLA will get soft because of the heat)

• Layer height: 0.2 mm

• Infill: 25%

Notes

• No supports needed.

• Secure with the original case screws through the corner holes.