Bill & Ted - 1989

Bill & Ted 3D printable model.  Prints in 3 parts.  The figures, the phone booth and the base.  First print the figures, adjusting the size to your needs.  Then print the phone booth, adjusting the size to fit the figures you printed, and then the base, adjusting size to meet the needs of the phone booth and figures.  Be careful when removing supports from the antenna, it is extremely fragile.

⚙ RECOMMENDED 3D PRINT SETTINGS

• Material: PLA or PLA+ recommended

• Layer Height: 0.16 mm for finer detail; 0.20 mm for faster prints

• Infill: 10–15% recommended for most models

• Wall Loops: 2–3

• Supports: Enable where necessary based on model geometry

• Build Plate Adhesion: Brim optional for smaller contact areas

• Print Orientation: Position the model for the best stability and minimal supports

• Scaling: Models may be resized, but check smaller details when scaling down

⚙ Printing Tip: Every printer and filament combination is different! Adjust settings as needed for the best results.

🔓 Join the Model Magic Club!

Want even more? Check out my Club memberships:

⭐ The Collector: Unlock thousands of exclusive original 3D models, with new creations added regularly!

💡 The Creator: Get everything in The Collector, plus submit up to 3 custom original model requests each month! Bring your ideas to life with models inspired by family, pets, hobbies, history, fantasy, and more!

From fantasy and horror to sci-fi, history, collectibles, and more, there's always something new to discover!

A quick note: Custom requests must be original or authorized designs. Copyrighted characters, branded designs, and other protected intellectual property are excluded without permission.

Thanks for visiting, downloading, and supporting Model Magic. Have fun printing! 😁