Skip to main content
F3D
Lọc nước qua lõi Brita Maxtra PRO (cho hồ cá) 1

6 images

Đồ Gia Dụng

Lọc nước qua lõi Brita Maxtra PRO (cho hồ cá)

By Bedrnik_1705939

Downloads
6
Likes
3
Views
89

Files 10 5.7 MB

  • Large_seal_template_1778930522.stlSTL · 68.8 KB
  • Small_seal_template_1778930524.stlSTL · 60.2 KB
  • Bucket_holder_1778930525.stlSTL · 173.8 KB
  • Flange_1778930526.stlSTL · 179 KB

Make a variant with AI

Build another version of this model.

Open Studio

Description

The device is used to filter water using filter cartridges from Brita. I use the Brita maxtra pro cartridge, which is designed for extremely hard water. The hardness of the water will not be completely removed, but it will greatly reduce it + remove the chorus from the water. One cartridge can filter 150L of water. I use 10L buckets from Bauhaus.

1) A hole with the inner diameter of the large seal is cut into the bucket (I use 10L buckets from Bauhaus.).

2) According to the template for small and large seals, I cut out seals from 4mm rubber (preferably silicone) or I print the seals from TPU.

3) Insert the small seal into the base followed by the filter cartridge (see picture)

4) I tighten the flange using the printed screws. There are spacers inserted between the flange and the base, which serve as spacers.

5) Insert a large gasket from the underside of the base.

6) I put the base into the bucket and secure it with a nut on the other side. Be careful, there must be a seal between the base and the bottom of the bucket with a minimum thickness of 2mm (better 3-4mm)

7) I will put 3 bucket holders on the second bucket. I recommend printing one holder and testing to see if it fits your bucket..

8)Then I place the bucket with the filter device on the bucket equipped with bucket holders. Pay attention to the diameter of the bucket so that the handles are large enough. Then I fill the large bucket with water and wait for the result.

Read more Show less

Print spec

Formats
stl
Model files
10
Total size
5.7 MB
Largest file
2.8 MB

0 comments

See all