
Giá treo tường cho Divoom Pixoo 64 dùng miếng dán Command Strip
- Downloads
- 4
- Likes
- 0
- Views
- 99
- Remixes
- 0
- Comments
- 0
Files 5 304.1 KB
- divoom_pixoo64_command_strip_wall_mount_1785588053.3mf3MF · 77.1 KB
- divoom_pixoo64_command_strip_wall_mount_1785588055.stepSTEP · 32.5 KB
- divoom_pixoo64_command_strip_spacer_1785588056.f3dF3D · 76.4 KB
- divoom_pixoo64_command_strip_wall_mount_1785588057.f3dF3D · 83 KB
Make a variant with AI
Build another version of this model.
Details
- Model ID
- #266393
- Category
- DIY
- Published
Description
Mounts a Divoom Pixoo 64 display on your wall using a command strip. The longer piece is the top hole, which the display will hang by. By only using one hole, you can easily adjust the angle after sticking the command strip to the wall. There is enough play to adjust the angle a good bit while still ensuring a solid connection.
The smaller piece is an optional spacer to put inside the bottom hole so that the display rests vertically against the wall instead of the bottom hanging towards the wall. This piece is a tight press fit into the hole.
Uses one large command strip. Stick on wall and follow command strip instructions (ex. wait 24 hours for maximum strength).
Print pieces on edge (not flat back) for strength, use normal supports for the bit that sticks out.
Print spec
- Formats
- 3mff3dstep
- Model files
- 5
- Total size
- 304.1 KB
- Largest file
- 83 KB
0 comments
You may also like 12 models
See all-

-

-

-

-

-

-

-
New -

-

-

-
New

