Giá đỡ iFixit Mako cho bảng ghim Wall Control

This is a remix of a simple holder for the iFixit Mako screwdriver set that adds hooks for the Wall Control peg board system.

The STL file should be oriented so that it prints on end requiring supports. This is to prevent the Wall Control hooks from delaminating under load. It's possible that it will be fine printed flat on the bottom, but personally I don't want to be woken up at 3 am with tools crashing to the ground.

Print Settings:

• Polymaker PLA Pro
• 6 Walls
• 25% Grid Infill
• Tree/Organic Supports