Nắp che hotend cải tiến cho Ender 5 S1 kèm mount CR-touch

The design I remixed is good but it required too many supports to print on it's side and it had a small surface on the top which results in low adhesion that almost prevented me from printing it in ABS. It also saves on material as it only required about 26g of ABS including supports, however this design does way more than the one I remixed which can be relevant for some

This design is only slightly altered from the original but the added material to the top makes it possible to print standing up like the original cover made by Kevin Cooper. Huge thanks to Kushmaker for coming up with the idea.

I bought the 5Pin 15cm version of the cabled listed bellow which allowed me to route the cable up and over the gantry so I can tie it in securely so it won't mode when running input shaper. I strongly suggest routing the cable this way

AliExpress JST1.25 ribbon cable 
Alternate link as old one no longer works

New probe offset after installation: 
X= -45.0mm
Y= 0.0mm