Ốp lưng bảo vệ FidgetBoy Ergo

Case for your FidgetBoy Ergo.  Based on the Ti version.  Friction fit should protect it from around 6 ft drops.  Version 1 has 3mm shell and bevels that don't print well.  Version 2 has 2mm shell and prints much better with revised bevels.  Each version has only a single shell; duplicate by your preferred method.  Two versions are technically compatible but due to shell thickness differences will not completely align so it is recommended to print two of the same version.  Can print without supports but raft or otherwise excellent adhesion is recommended for v1.