Ngàm thay thế cho kẹp PARKSIDE Powerfix

Don’t throw away your broken clamps! This is a heavy-duty replacement jaw for the Powerfix Profi+ one-handed clamps (commonly sold at Lidl), though it is designed to be compatible with many similar "budget" quick-grip clamps found at hardware stores.

This model is a direct drop-in replacement. It is designed to reuse all your original hardware, including:

• The original mounting screw and nut.

• The original red rubber protective pad.

Print Settings

To ensure the part can handle the clamping force without delaminating, I recommend the following "overbuilt" settings:

• Material: ABS or ASA (recommended for strength and slight flexibility). PETG is a good secondary choice.

• Wall Loops: 6 (Essential for structural integrity around the bolt hole).

• Infill: 50% (Gyroid or Cubic recommended).

• Layer Height: 0.16mm (Provides better surface area for layer adhesion).

• Supports: Yes (Required for the internal nut housing and overhangs).

• Orientation: Print on its side for maximum strength (avoids the clamping force pulling against layer lines).