Thước cặp Vernier - 110 mm (In nhanh hơn)

3D printable callipers for quick on the go measurements that don't require ultra high precision.

Print with a 0.2mm nozzle. I used PETG for its strength, but other materials would work too.  
Print the depth gauge separately, and use a small amount of CA glue to glue in place. 

Same design as the original, however I removed the hexagonal shapes, to make it all infill, as well as printing the depth gauge as it own piece to reduce the amount of support material needed. 
Overall, this account for a 27 minute reduction in print time, and a 0.8 g saving in filament. These calipers are fully compatible with the original design, so you can mix and match the two.

As stated by the original designer, these are accurate to +- 0.2 mm, and good for quick measurements that don't require precision.