Ho Door (Đã sửa lỗi)

FYI: The only thing that didn't print well where his fingers. I'm not going to fuss over that but using supports will likely fix that. I don't mind too much as this is a fun little thing that will be in a low light Lego display room. (I collect)

Printed using: Polymaker CosPLA, 6mm nozzel, .2mm layer hight, 20ish % infill, balanced Prusa settings with the Polymaker Polyterra profile selected. I usually increase the bed temp 5' as with my machine it just seams to work better.

Full disclosure:  Im new to it but, I do get a financial kickback if you use my Polyaker CosPLA link above.  I would greatly appreciate it if you use my link if you are already in the market for this filament. Thanks!