Hornet 13 - Phiên bản Fanon

Poseable hornet model with more human like proportions. I wanted to make a version that's easier to print, dress, and pose. (No sewing required!) 

Assembly is mostly the same as Carbon 13 - Type F.

A template is included for you to make hornet's cloak/poncho. Simply trace and cut it out on some red fabric, wrap it around hornet's body, and fix it in place with glue. I recommend experimenting with folding and playing around with the fabric before gluing in place

Want one that looks more like Hornet's in game model? Check out:

Printing instructions

The model pictured used PLA for the body parts (+needle) and ABS for the joints. I recommend that you do the same. The joint parts are so small that you probably don't need an enclosure

For one figure, you will need all of models in Modified Body and Modified Joints as well as the following models from the original Carbon 13 (Type F) page (linked below). LowerArm and UpperArm need to be printed twice

• 1x Body Part: footleft

• 1x Body Part: footright

• 1x Body Part: toeleft

• 1x Body Part: toeright

• 1x Body Part: Pelvis

• 2x Body Part: hip

• 2x Joint: Pair of hands (L&R)

• 3x Joint: shoulderandhead

• 2x Joint: clavicle

• 2x Joint: elbow

• 1x Joint: groin

• 2x Joint: hip

• 2x Joint: knee

• 2x Joint: ankle

The two parts of the needle friction fit together. Superglue (or any adhesive) is required to fix the eye inserts in place. 

Support is required for the head model. Don't put any inside the socket, otherwise it'll be impossible to remove

Print everything except for the head and both parts of the needle in black. Print both halves of the needle in silver or grey. Print the head in white.

Currently working on runners, a better cloak guide, and general refinements.

Changelog:

Initial release (v1.0):

• Made a more human like sculpt of hornet

  • I went for a combination of the promo art and thirst traps, and I think I did a good job. Please let me know if that is not the case

  • If you want a thirst trap version, put this model's head on https://www.printables.com/model/1643593-cyber-thunder-carbon-13-thick-conversion-kit

Tweaks and things (v1.1):

• Opted to revert the pelvis design back to the original carbon 13 version

  • Will be available in Alternate Parts

• Fixed an issue where pommel would fall off of the needle

• Made the chest slightly larger

• Added the remade hand models from the game accurate version to Alternate Parts

• Added the extended neck model to Alternate Parts