Skip to main content
F3D
Miếng chèn gia cố cho móc treo giày Sneaker 1

3 images

Đồ Gia Dụng

Miếng chèn gia cố cho móc treo giày Sneaker

Remix of Giá treo giày sneaker chống thú cưng phá hoại By DDS3DPrintingDesign

By Maksim_4190965

Views
62

Files 1 79.6 KB

  • Shoe_Hanger_Insert_1774089436.stlSTL · 79.6 KB

Make a variant with AI

Build another version of this model.

Open Studio

Details

Model ID
#260365
Category
Đồ Gia Dụng
Published

Description

I printed the orginal and after some time it would fail but always in the same place. Then I noticed it was because the natural (and recommended) way to print this would always expose the layers lines to high stress.

So I created this insert from the original that you print first and then you glue into the pocket on the original. This reinforces the original at the failure point using 3D printed layers which are orientated in their strongest direction to the applied load. This composite approach gives the strongest structure possible.

It's simple and quick to print (5 minutes). The best workflow is to print this first. Allow the bed to cool and remove. Then print the main hook but add a pause at layer 193 (Z 38.60mm). Now glue in the insert to act as support for the next overhang layer. I used cyanoacrylate (superglue) with an activator to aid adhesion.

Read more Show less

Print spec

Formats
stl
Model files
1
Total size
79.6 KB
Largest file
79.6 KB

0 comments

See all