Skip to main content
F3D
Khung FEP có thể bảo trì cho Anycubic Photon 1

4 images

Máy In 3D

Khung FEP có thể bảo trì cho Anycubic Photon

By IvanKaminski_1012854

Downloads
8
Likes
2
Views
151

Files 1 286.9 KB

  • Anycubic_Photon_serviceable_vat_fep_1774075030.3mf3MF · 286.9 KB

Make a variant with AI

Build another version of this model.

Open Studio

Description

I designed a replacement FEP frame for the Anycubic Photon because original replacements are becoming difficult to find and many existing designs online are not very reliable.

This version is fully serviceable, meaning you can easily replace the FEP film without needing a new frame.

The design has been tested on my own printer, and after several iterations it works reliably.


Hardware Required

  • 14 × M2.5 heat set inserts
    (L4 × OD3.5)

  • 14 × M2.5 × 6 mm countersunk flat head screws


FEP Installation

  1. Cut a piece of standard FEP film slightly larger than the frame.

  2. Place the FEP between the two frame parts.

  3. Install the screws and tighten them evenly.

  4. After tightening, trim the excess FEP around the edges.


Installation on the Vat

Mount the assembled FEP frame onto the vat.

Tighten the vat screws in a cross pattern, gradually and evenly.


Print Settings (tested)

Material: ABS

  • 40% infill – Gyroid

  • Ironing enabled on top surface

  • Print speed: 60 mm/s

  • Flow: 30 %


Notes

I printed 5 prototypes before achieving the final fit and tension.
The frame has been tested on my own Anycubic Photon and works correctly.

Read more Show less

Print spec

Formats
3mf
Model files
1
Total size
286.9 KB
Largest file
286.9 KB

0 comments

See all