CR-10 NG - Bản độ coreXY (beta)

THIS IS CURRENTLY INCOMPLETE, CHECK THE CHANGELOG BELOW  

        CR-10 NG beta - coreXY conversion

This printer is based off of the Ender 3 NG beta v1.1. Supports CR-10 and CR-10S.

   PRINTER OVERVIEW 

This project is a DIY conversion based on CR-10.

Main goal was to target CR-10 in the same style and spirit as Ender 3 NG.

   FEATURES: 

• Build volume: 305 x 310 x 345 mm.
• Printer size (W x L x H): 478 x 582 x 520 mm.
• *Compatible with CR-10, CR-10S, .. for now.

FUTURE UPGRADES: 

• Enclosure
• Optional Ultimate Frame (from v1.2)
• Optional 3 Z Axis Rods (from v1.2)

For more information, better orienting in the files and Bill of material, look at the attached documents. Though I highly recommend to use the online versions so you always use the up to date version.

• Bill of material, Printed parts:
• Build manual:                            
• Printer overview:                      
• STEP assembly:                        

For more information join the RH3D Discord, navigate to Ender 3 NG, then user-mods and then the “CR10NG - Mod for CR-10 V1” post.

Complete changelog:

EDIT 07.06.2025 - Added CNG-BCS step/stl files

EDIT 16.03.2025 - Updated frame parts for electronics panel mounting: CNG-FTL1, CNG-FTL2, CNG-FTR1, CNG-FTR2. Added frame cap for CR-10S: ENG-BRC_509. Electronics enclosure parts added: CNG-EFBA, CNG-EFBB, CNG-EFLA, CNG-EFLB, CNG-EFRA, CNG-EFRB, CNG-EMA, CNG- EMB, CNG-ESA, CNG-ESB, CNG-EPA1, CNG-EPA2, CNG-EPA3, CNG-EPB1, CNG-EPB2, CNG-EPB3, CNG-EPC.

EDIT 03.12.2024  - Added folders, stl and step, for all the frame parts, all bed parts but none of the electronics enclosure, the files are modeled but not verified positionally like DIN rail locations, wire holes, alignment of electrical components etc.

EDIT 03.12.2024 - Copied and edited the sections from the Ender 3 NG printables page from RH3D as well as listing the difference table for printed parts