Đế Bento Box phiên bản cải tiến cho Elegoo Centauri Carbon

I've removed all the mounting points and replaced them with two 10x60x3mm magnets. Most importantly I cut out the rear corner so it can sit flush against the metal panel (important for magnets). 

I used some super glue to fix the magnets found  in the link below. 

https://a.co/d/aLqvHJA

I've also connected my fans to the extra light port on the main board as I'm not too concerned about the dim lighting. Do this at your own risk. As far as I understand the fan specs, the draw should be way under the 1A port limit. Correct me if I'm wrong! So far seems fine. 

I recommend using organic supports for the rear notch and the magnet cut outs. 

Download the rest of the Bento Box from the og link below. Enjoy!

https://makerworld.com/en/models/12786-bentobox-v2-0-activated-carbon-filter#profileId-24358