Case Raspberry Pi Zero 2W - Bản remix tiện lợi

This is a remix of @oogoom's really nice Raspberry Pi Zero 2W case design to accommodate a header and heatsink openings on the top of the board. I used OpenScad to add the openings to the lid STL. I also added two small slots on one end to allow for easier opening of the snap fit case. I removed the header opening from the body STL. 

Note that the pi-zero-2w-lid-remix.stl model needs to be flipped with the top face down before slicing. I printed each of the two files with a 0.6mm nozzle with PLA and a 0.2mm layer height. No supports are required.

For those interested in remixing STL files with OpenScad, below is the code. I didn't attach the SCAD files since you have to change the path to the two STLs downloaded from the original model at https://www.printables.com/model/237095-raspberry-pi-zero-2-w.

The OpenScad code for the body follows, just change the import line with the path to the original Body.STL. The cube fills the header opening.

// Pi Zero 2W Case remix

import("change-path-to-Body.stl");
translate([-26.5,8,-1.4])
cube([52.5,7,2]);

The OpenScad code for the lid follows, just change the import line with the path to the original Lid.STL. The first cube fills the logo, then additional cubes remove the openings and add slots.

// Pi Zero 2W Case Remix

difference(){
union(){
import("change-path-to-Lid.stl");
translate([-20,-15,8])
cube([40,30,3]);
}
translate([-12,-10,8])
cube([16,16,3]);
translate([-26.5,8,8])
cube([53,6,3]);
translate([33,10,5])
cube([2,4,2]);
translate([33,-14,5])
cube([2,4,2]);
}