Móc khóa Labubu in 3D

These dolls are everywhere now, and apparently some of them are worth a lot of money. I thought it would be a fun challenge to design a 3D Labubu doll on Nomad Sculpt and 3D print it. The print came out so nicely that I painted it using simple acrylic pens and the result was pretty cool. 

No supports needed! A brim is advised, especially for the “standing position” model. Make it larger (10mm) for better adhesion.

Some of the models are suffixed with “fuzzy”, these models have paint-on fuzzy skin already applied on PrusaSlicer (see the last picture for an example - looks pretty cool!).

Printing Advice 

• 0.15mm Structural for fine lines, easier to paint
• 20% infill
• Brim of 10mm
• Seam position set to “rear”

Making Off

The model was designed on Nomad Sculpt. Here is a speed-up video of the process: