
Hang Trú Ẩn Dưới Lòng Đất Cho Bò Sát (Underground Reptile Hide)
- Downloads
- 745
- Likes
- 176
- Views
- 4,274
- Remixes
- 0
- Comments
- 0
Files 10 9.7 MB
- underground-hide-top-right-entrance_1773809077.stlSTL · 354.9 KB
- underground-hide-top-left-entrance_1773809078.stlSTL · 354.8 KB
- underground-hide-bottom_1773809080.stlSTL · 421.6 KB
- underground-hide-bottom-alt_1773809080.stlSTL · 306 KB
Make a variant with AI
Build another version of this model.
Details
- Model ID
- #256080
- Category
- Đồ Gia Dụng
- Published
Description
Edit 2026/03/17:
All STEP and STL files have been re-uploaded with the astroviv logo due to intellectual property infringement. If you see any versions of this hide that are not posted by me, Dylan, @astroviv/@creu3d, please report!
Intro
This is an underground gecko hide with a removable top for easy access and open bottom for exposure to substrate. This hide works well as a humid hide and has been great for holding moisture with a damp 70% topsoil, 30% play sand mix inside.
The top has "left" and "right" versions - both are simply mirrored versions of each other to give you variability to place the entrance on either side depending on what fits your terrarium best. They are compatible with all underground pieces.
The "bottom" has two versions - one that's enclosed with air/peep holes and one with peep holes and openings. I created the version with openings to give my gecko the ability to dig out his own tunnels from inside the hide.
Printing
Supports are required for either top version. Slim tree supports have worked fine for me with all instances of printing.
I added the STL files for each piece as well as 3mf files that I used for the normal and fuzzy variants.
Printing with fuzzy skin gives it a more natural look compared to normal walls, and can be useful to geckos when shedding. Please make sure to sand down any sharp imperfections in the print to protect your pet!
Please make sure you also seal the print with reptile safe sealant to prevent bacteria growth in the cracks and layer lines. I use polyurethane spray sealants on my PLA prints for clear-coats.
Edit 2025/01/28:
STL files have been added in place of STEP files so they can be viewed in the native 3D viewer in Printables.
Edit 2025/06/14:
STEP files have been added back in place of STL to rectify failed prints when using STL files - see @Smithy18772_2201999 's comments. Many thanks for helping troubleshoot the failed prints!
Edit 2026/03/05:
STL files have been regenerated and reuploaded... I couldn't replicate the issues @Smithy18772_2201999 was having with the previous STL files with the new ones, so they should be good.
Print spec
- Formats
- 3mfstepstl
- Model files
- 10
- Total size
- 9.7 MB
- Largest file
- 2.1 MB
0 comments
You may also like 12 models
See all-

-

-

-
New -

-
New -

-

-

-
New -

-


