Bộ chuyển đổi Dyson BLOWER (Đầu thổi hơi)

Nerf gun version: https://www.printables.com/model/1295612-dyson-nerf-style-blaster

📦 Requirements:

2 x 5 mm ball magnets (inserted after printing — no mid-print pauses required)

Superglue (or optionally tape for a temporary fit)

🖨 Print Instructions:

Print with supports

After printing, insert the two 5 mm ball magnets into the holes at the bottom (would recommend using glue or melted filament on them)

Glue the top part to the Dyson filter extender

The small tip does not need to be glued — it's press-fit

Optional: light sanding for a better fit depending on printer tolerances

⚠ Important Notes:

Do not use the boost/power mode — the pressure may damage the print or what you're cleaning

Use at your own risk — I take no responsibility for damage or misuse