
Khung nắp trên từ tính siêu mỏng cho Core One
Remix of Nắp trên gắn nam châm cho Prusa Core One - tùy chỉnh mọi kích thước By BrutusBoots_42897
- Downloads
- 128
- Likes
- 52
- Views
- 869
- Remixes
- 0
- Comments
- 0
Files 2 439.3 KB
- ThinTopCoverFrameCoreOne.stlSTL · 270.8 KB
- ThinTopCoverFrameCoreOne.stepSTEP · 168.4 KB
Make a variant with AI
Build another version of this model.
Details
- Model ID
- #251676
- Category
- Máy In 3D
- Published
Description
All of the magnetic top cover frames are fairly thick. I wanted a frame and magnets for my top cover, but also wanted it to be as thin as possible to blend in with the frame of the printer.
I liked that the version by @BrutusBoots uses the original plastic rivets instead of screws, but I still found it a little thick. My version uses the original rivets like his, but lifts the acrylic by only 2.6mm.
To get minimal thickness, there are no handles and it can only accommodate 2mm thick magnets. There are four 20x5x2.2mm recesses on each piece for magnets. The magnets I bought from Amazon are undersized, so I use a drop of superglue to hold them in. If you have properly sized ones they should press fit.
In place of a handle, I am using the Core One Vent Handle by TJS to both control the vent and remove the cover.
Update 2026-01-03 - I am now using my 3 arm remix of TJS's handle.
Print 4 copies. They slot together and are held in place by using the plastic rivets to attach the acrylic top to your printed frame parts.
I printed my frame in PETG and it fits well with tight joints and proper hole alignment.
I also tried ASA, but due to shrinkage there were gaps and things didn't align perfectly.
Print spec
- Formats
- stepstl
- Model files
- 2
- Total size
- 439.3 KB
- Largest file
- 270.8 KB
0 comments
You may also like 12 models
See all-

-

-
New -
New -
New -

-

-

-

-

-

-


