
Ống dẫn khí 200mm cho Antminer S17
- Downloads
- 0
- Likes
- 0
- Views
- 77
- Remixes
- 0
- Comments
- 0
Files 5 3.5 MB
- AirDuct_TOP_1773555203.stlSTL · 1.2 MB
- AirDuct_Bottom_1773555204.stlSTL · 400.2 KB
- AirDuct_Seal_1_1773555205.stlSTL · 532.8 KB
- AirDuct_Seal_2_1773555205.stlSTL · 1.2 MB
Make a variant with AI
Build another version of this model.
Details
- Model ID
- #251210
- Category
- Đồ Gia Dụng
- Published
Description
Print Settings
-
Material: PETG (Recommended for heat resistance)
-
Infill: 15%
-
Design: Two-piece, support-free printing.
-
Optional Gaskets: TPU (100% infill, 0.6mm / 3 layers thick) for airtight sealing.
Required Hardware
-
Screw Type: M4 (or applicable diameter for your model).
-
Length: >45mm (The original 42mm screws will be too short due to the added thickness of the duct).
Installation Notes
-
The Screw-Plate: The duct is secured to the PSU using a dedicated screw-plate.
-
Clearance: Be aware that the inner screws are located in a tight-clearance area; a thin-profile driver or ball-end hex key is recommended.
-
Sealing: Use the optional TPU gaskets between the duct and the PSU face to maximize static pressure and prevent air bleed.
⚠ Disclaimer
Modifying your mining hardware can improve thermals but is done at your own risk. Ensure your fan speeds are monitored after installation to verify airflow efficiency.
Print spec
- Formats
- stl
- Model files
- 5
- Total size
- 3.5 MB
- Largest file
- 1.2 MB
0 comments
You may also like 12 models
See all-

-
New -

-

-

-

-

-

-

-
New -

-


