Bộ phụ kiện nam châm cho robot HP Otto

This young robotic gentleman needs some class!

Give your Otto the ability to wear different hot-swappable fashionable accessories. With this set, you can easily change his style depending on the occasion.

The set includes:

• Solid color tie

• Striped tie

• Bow tie

• Ribbon

• Anything with a magnet

The face is designed to be compatible with round magnets up to 5x3 mm, allowing you to attach accessories quickly and securely.

Printing Settings

• Layer height: 0.2 mm

• Nozzle: 0.4 mm

• Infill: 10-15%

• Material: PLA recommended

Bow tie and ribbon models require supports.

Stripped tie can be printed without any kind of MMU, with manual color swap.

Assembly

1. Insert 5x3 mm round magnets into the dedicated slots in the face plate.

2. To properly seat the magnets in their pockets, use another magnet from the opposite side to pull them into the correct position.

3. Accessories attach magnetically to the face.

Using a small drop of super glue is recommended to secure the magnets permanently, although it is not strictly required if the fit is tight enough and robot does not shake a lot.

Materials used in the photos:

• Sunlu - Light Blue

• Prusament - Lipstick Red

• Prusament - Marble Grey

(I don’t have the distance sensor installed, so the eyes shown in the photos are also 3D printed.)