Miếng chặn passthrough MMU cho máy in Prusa Core One L

This is my remix of the Core One Passthrough originally designed by dancan13f. The original MMU mounts work on the Core One L, but the L lacks the holes in the acrylic plate and the hole alignment of the Core One L enclosure itself differs significantly from the Core One/+.

Refer to dancan13f's original instructions. they are very comprehensive. Here are the key differences: Holes in the cutting guide are only there to line up the cutter, there are no corresponding holes in the L's acrylic lid. Tolerances were extremely tight, make sure to pre fit the parts to line up holes for the screws and trim as needed.

Suggested Print settings:

.15mm balanced

15% infill, 4 walls

cover and guide in PTFE

Suggest base and disk in PC-CF if possible

Print the cover and base on a textured plate face down

For the acrylic plate I suggest drilling the 3mm hole, scoring deeply with a box knife and then cutting with a dremel circular cutter