Khối Lập Phương Emoji (Emoji Faces Cube)

To each side of the cube is applied an Emoji face, created using Tinkercad.

The corners and edges of this cube have been rounded to remove sharp edges.

The cube can be used to stamp modelling clay or as printing blocks to apply paint to paper or fabric.

Size: 40(W) x 40(H) x 40(D) mm

Weight: 30g

Print Details

Filament: PLA Orange

Layer Height: 0.12mm

Infill Density: 25%

Infill Pattern: Cubic

Wall count: 4

Base Adhesion: Skirt

Support:
Support is required due to the small contact area of the model (~20 x 20 mm), compared to the full base dimensions of (40 x 40 mm), which results in a overhang due to the rounded edges.
Structure: Normal
Placement: Touching Buildplate
Overhang Angle: 50 Degree
Pattern: Grid

Post processing

This should be minimal but light sanding may be required subject to print quality after removal of the support.