Khối Lập Phương Nguyên Âm (Vowel Cube)

Each letter of the common vowels (a, e, i, o, u), are applied to each side of a cube, created using BlocksCAD.

The letter Y is also classified to a less extent as a vowel due to it sounding like the letter I, but currently replaced with a ? in this case rather than the option of leaving it blank.

The corners and edges have been chamfered to remove sharp edges.

The cube can be used to stamp modelling clay or as printing blocks to apply paint to paper or fabric.

Size: 40(W) x 40(H) x 40(D) mm

Weight: 35g

Print Details

Filament: PLA Orange

Layer Height: 0.12mm

Infill Density: 25%

Infill Pattern: Cubic

Wall count: 4

Base Adhesion: Skirt

Post processing

This should be minimal but light sanding may be required subject to print quality.