Nắp đậy thùng rác Garnish Trashcan Top

Holds back garnishes and other stuff, while letting liquid passthrough with ease. It even have a lip on the inside to make sure the droplets go directly into the waste and doesn't spill everywhere.

Originally made for rectangular trashcan in bars with measurements 28cm x 58cm x 60cm.

Printed on Prusa Core One

ST-PLA from 3D Saga

10% Infill, with 4mm brim depending on print orientation, flat surfaces might lift without.

Snug supports is recommended for 250x250mm print plate. I could not get organics to fit on the CoreOne print plate with this size print.