Skip to main content
F3D
Giá Treo Dù Golf Gắn Tường 1

3 images

DIY

Giá Treo Dù Golf Gắn Tường

By RanTheLab_197194

Views
46

Files 3 238.7 KB

  • GolfUmbrellaWallCaddy_1773473614.3mf3MF · 154.5 KB
  • GolfUmbrellaWallCaddyGateSolid_1773473615.3mf3MF · 48.6 KB
  • GolfUmbrellaWallCaddyGateFlex_1773473616.3mf3MF · 35.6 KB

Make a variant with AI

Build another version of this model.

Open Studio

Description

They say the key to a neat garage is to get your stuff off the floor.  After kicking around these umbrellas, I decided they needed a new home.  This Golf Umbrella Caddy is short and mounts to the wall.  This one is mounted on a coat hook board which is attached to the wall, so there is 3/4" for the umbrellas to lean back and relax against the wall above.  Don't think it matters much, though.  The umbrellas stand vertical, so there is not much force side-to-side or front-to-back.

Note the dimple where the tip sits does not have a drain hole.  Our umbrellas are always stored dry.

Printing tips

  • Print the main part on its back for vertical layer lines and no supports required.

  • It is intended for the 'square-looking' gate be printed in FLEX material.

  • The curved gate could be printed in solid or flex.

Printed with .2 layers in PETG.

The gates drop in the key holes and could be glued in if desired.

Read more Show less

Print spec

Formats
3mf
Model files
3
Total size
238.7 KB
Largest file
154.5 KB

0 comments

See all