Carbon/Dummy 13 - Power Claw BẢN REMASTERED!

Finally, I can fix the biggest problem with the original claw! Some people said they had issues printing the original claw fully upright since the joint might snap off due to the print lines. Not anymore!

I went back and refined the original claw a bit, cleaned up some of the vertices, and added a bit more bulk to the armor. I also was finally able to make something I've wanted to for a long time: POWER FISTS! There's currently three to pick from: a fist, an open hand, and a "holding" fist. The "holding" one fits any Dummy accessory at ~175% size, it's a bit of a squeeze depending on the accessory though, I don't know why. Some printed out fine, some were too small, some were too wide, it's weird.