
Bahtinov mask cho kính thiên văn Sky-Watcher BKMAK 150
Remix of Kính viễn vọng Bahtinov Mặt nạ (có thể tùy chỉnh) By agrif
- Downloads
- 0
- Likes
- 0
- Views
- 86
- Remixes
- 0
- Comments
- 0
Files 4 1.8 MB
- bahtinov_1773275204.scadSCAD · 4.7 KB
- bahtinov_1773275205.stlSTL · 176.5 KB
- bahtinov_1773275206.3mf3MF · 73.9 KB
- bahtinov-2_0.4n_0.25mm_PLA_MINI_4h3m_1773275207.bgcodeBGCODE · 1.6 MB
Make a variant with AI
Build another version of this model.
Details
- Model ID
- #244624
- Category
- Giáo Dục
- Published
- License
- Creative Commons — Attribution
Description
I wanted to have the Bahtinov mask for my MAK 150 and couldn't find one, so I made my own.
Based on the original, I have set it to be 175mm external wall diameter (part going into telescope's tube) and have 8mm border. I have added small protrusions for better fit. I also added two handles so it's easier to remove. My first version (on the photos) was printed without these and I still can take of the mask without problems, so it's a bonus.
As I have Prusa Mini+, I have prepared a project with border cut so it fits the printing table. It has also disabled skirt. Of course there is also full model for bigger printers.
Printed with PLA on draft settings and it is good enough. I just had to make sure, that whole table is covered with glue because there are a multiple outlines at the start and its easy to lose a few edges.
Thanks to the Author of original scad file. I have attached my modified version. Code is for sure far from perfect - I have combined original one with changes supported by AI and my poor imagination (AI didn't get original code, I just asked questions and fit the outputs to base design).
Print spec
- Formats
- 3mfbgcodescadstl
- Model files
- 4
- Total size
- 1.8 MB
- Largest file
- 1.6 MB
0 comments
You may also like 12 models
See all-
New -

-

-

-

-

-

-

-

-

-

-


