Mặt nạ Warden Operator [Tương thích với mũ FAST]

Note:

Since this mask does not just sit on the front but also wraps around your face i highly recommend doing some test prints with slices to check if it fits your face or needs adjustment. 

While working on it, i had to adjust the model multiple times because my cheekbones just wouldnt fit. 

Mounting:

For mounting I recommend using firm elastic bands to mount the mask to the FAST helmet clips. Just put them through the slit in the back and your helmet clips.

Then put on the helmet, put on the mask and slide in the clips

If you want additional clips for your FAST Helmet you can check out this model:

The model also has a unused mounting point in the top front, in case you need to hook the mask into your helmet. In my testing the pull from the elastic bands and the form of the mask was enough to hold it properly. But i wanted to leave that in, just in case

Disclaimer:

Yes the Model topology is hideous and its awful. I just wanted to get this one out and took some shortcuts. Especially the inside had to be stripped down quickly and therefore looks like this. I dont have much time on my hands right now and this project was supposed to be out long ago already.

Feel free to adjust it and remix it, if your eyes dont hurt too much from looking at it :'D