Skip to main content
F3D
Giá đỡ ray treo trần Ikea Vidga thay thế 1

8 images

Ý Tưởng Khác

Giá đỡ ray treo trần Ikea Vidga thay thế

By Tec007

Downloads
422
Likes
30
Views
1,353
Comments
17

Files 4 2 MB

  • Ikea_Vidga-rail_holder_0.2mm_PETG_MINI_10m_1765579864.gcodeGCODE · 309.9 KB
  • Ikea_Vidga-rail_holder_6pcs_0.2mm_PETG_MINI_52m_1765579864.gcodeGCODE · 1.7 MB
  • Ikea_Vidga-rail_holder_1765579862.3mf3MF · 25.2 KB
  • Ikea_Vidga-rail_holder_v1_1765579863.stlSTL · 45.6 KB

Make a variant with AI

Build another version of this model.

Open Studio

Description

I had to cut long curtain rail Ikea Vidga into two pieces, but there were ceiling mount holder only for one part, therefore I created this model so I could use the other part, too. The original holder design is slightly modified for better printing. I have used transparent PETG to make holders less visible.

Print instructions

I used PETG in my case. No special setting is needed - I used 0.2 mm layer height for 0.4 mm nozzle, infill is not relevant (present only in minor part of the model). Supports should be enabled everywhere to hold upper part of the model (I found them quite easily separable without any negative impact on final printed part).

-------------------------

Delší kolejnici pro závěsy Ikea Vidga jsem rozřízl na dvě části, ale v balení jsou držáky pro montáž do stropu pouze na jednu takovou část, proto jsem vytvořil tento model tak, abych mohl využít i zbývající kus. Originální design držáku je lehce upraven pro snadnější tisk. Pro svůj výtisk jsem použil transparentní PETG, aby byly držáky méně viditelné.

Tiskové instrukce

V mém případě jsem použil PETG. Nejsou potřeba žádná speciální tisková nastavení - nastavil jsem výšku vrstvy 0,2 mm pro trysku o průměru 0,4 mm, výplň není důležitá (nachází se pouze v malé části modelu). Podpěry by měly být povoleny všude k podepření vrchní části modelu (z mé zkušenosti jdou celkem snadno oddělit a na výsledný výtisk nemají žádný negativní vliv).

Read more Show less

Print spec

Formats
3mfgcodestl
Model files
4
Total size
2 MB
Largest file
1.7 MB

17 comments

See all