Khối chà nhám tường (Drywall Sanding block)

I scoured the internet and to my shock it appears not a single person has modeled a drywall sanding block sized for 11 1/4in x 4 3/16in sand paper.. So here it is! Excuse the pink I was using up old filament :D

To use just loosen the bolt, slide the sandpaper under the pinch block, press it down with your fingers to crease it in the pinch channel then tighten the bolt.

NOTE: Even though the bolt is 3d printed it is surprisingly strong because of it's size and thread type, I haven't broken one yet, however it is advised not to crank it down too crazy hard.

I glued foam to the bottom of my block like the store bought ones have since it evens out the finish when sanding but this is optional.

• PRINT SETTINGS
  Any hard filament should work, but the stronger the filament the better since it's a work tool.

• Tress slim support is fine

• .24 layer height recommended for a mix of good layer strength but also keeping good thread tolerances on the screw parts

• 4 or 6 wall loops

• 30% adaptive cubic infill for best strength and lower filament usage

• Glues stick on bed recommended, I had a corner of my sander pop up from the print bed due to it warping as it cooled.

If you would like to leave a tip for my hard work you can do so here :D https://www.paypal.com/ncp/payment/Y5DRF7PN8S5AJ