DUMMY 13 đi COMIC CON - Catwoman V1.0

13. Dec. 2023:

• Incorrect naming corrected
• Missing part added

Sorry for that!

Based on DUMMY 13 Beta - Oct. 2023 

DUMMY 13 Printable Jointed Figure © 2023 by Lucky 13 Toys is licensed under CC BY 4.0

Get your Dummy 13 here: /model/593185

DUMMY 13 loves COMIC CON! 

So I have started to design a whole series of characters and costumes for DUMMY 13. This is another costume from the series "DUMMY13 goes to COMIC CON".

The aim is to preserve the charm and simplicity of Dummy 13.

Content of CatDUMM, sorry Catwoman:

• Mask
• Hands with long fingernails
• High-heel-booties (optional)
• Sexy female body 
• Whip handle
• Whip holster on the hip
• Other parts are standard parts 

Get more:

• More outfits  /@Mici/collections/967681
• More weapons /@Mici/collections/1103020
• More hands /@Mici/collections/1103017

Female Armor:

For other female body versions, have a look at my female body set: /model/637152

Whip:

• You will need a piece of cord or very soft TPU
• Slide it into the handle
• Fix it with glue

High-heel-booties: 

Catwoman is still not hot enough for you? Take a look here: 

/model/659695

Mask:

Slide the head into the mask and press it in with gentle force on the chin.

If this is not possible, it is probably due to the following points:

•  Check the inside of the helmet (mostly the top and behind the eyes) to see if it has been printed cleanly and remove any filament debris that is sticking out
• Has the brim been removed cleanly?
• The elephant foot can cause the inner rim to be a little too narrow, just sand the inner rim down a little or work it with a knife

Printing:

Layer height

Brim

Supports

Mask

0.15mm

x

x (below the eyes)

Hands

0.10mm*

-

-

Whip handle

0.15mm

-

-

Hip holster

0.15mm

-

-

Body

0.15mm

-

-

Neckline insert (multi part)

Best with 0.25 nozzle @ 0.05 mm

-

-

Original parts

Please note the recommendations on the original model

* Since I mostly use rPLA, I sometimes had the problem that some fingernails broke off easily.

• Use high quality filament
• It can be useful to print the fingernails with a lower layer height (0.05mm) to obtain a more rigid structure, e.g. by using modifiers in Prusa Slicer