Skip to main content
F3D
Ngàm gắn Filament Sensor Ender 3 v3 KE kèm PTFE Guide 1

5 images

Máy In 3D

Ngàm gắn Filament Sensor Ender 3 v3 KE kèm PTFE Guide

Remix of Đế Cảm Biến Sợi Nhựa Cho Ender 3 v3 KE (Không Dùng Giá Đỡ Gốc) By EtherQ_1817839

By fatmax_1786363

Downloads
1,443
Likes
161
Views
6,298
Remixes
1

Files 5 2.8 MB

  • KE_Filament_Guide_1772782854.stepSTEP · 389.1 KB
  • Sensor_Frame_Mount_1772782855.stlSTL · 581.1 KB
  • Sensor_Back_Mount_1772782856.stlSTL · 752.6 KB
  • KE_Filament_Guide_1772785359.f3dF3D · 288.5 KB

Make a variant with AI

Build another version of this model.

Open Studio

Remix versions 1

See all 1 remix

Details

Model ID
#240067
Category
Máy In 3D
Published

Description

Filament sensor mounting kit with PTFE tube to move a spool to the side of your printer.

The assembly uses stock screws. But if you're using this frame brace (very cool by the way), you'll need two longer screws than stock. I used M3x30mm.

You will also need a 4mm diameter PTFE tube, as you can see in the attached photos. The tube should fit tightly into the holes, but it depends on the calibration of your printer. Anyway, I have attached the source files Fusion 360, so feel free to customize the model to your case

The models can be printed without supports. The positioning of the models can be seen in the attached image (the green ones).

Important note! After installing the kit, you will most likely need to calibrate the flow, because this setup has higher friction than stock one, so you may get a little underextrusion.

Read more Show less

Print spec

Formats
f3dstepstl
Model files
5
Total size
2.8 MB
Largest file
896.8 KB

0 comments

See all