Hộp đựng insulin cho 2 lọ 10ml

Press fit two 5mm x 5mm magnets in the hole in the center. Mind polarity.

If your printer's calibration is a bit off, you can glue those in place if the hole is too big, or drill them out with a 5mm drill if the hole is too small.

I do not use insulin myself. Any feedback on how to improve this model from the people who actually use it, is much apreciated.

There are multiple bodies in the STEP and STL file. Split them up before printing.

I included separate TOP and BOTTOM STL files for your convenience.

Update: 2025-05-09
There is now a “With cap” variant that fits the bottles with the plastic vial cover on it. I have no bottles to test it with, so if you print this one, please report back if this fits well or not 😅.