Miếng Gắn Mặt cho Tiny Crawling Pumpkins

Insert pieces to bring some extra pop to each of the Tiny Crawling Pumpkins by jajaum3d.

Helpful Info

Since these are very small parts, rafts or brims are recommended when printing. Afterwards, a bit of cleanup with a hobby knife may be needed before gluing them in place to ensure the parts fit nicely. 

If these face inserts are too tiny and hard to work with at the original scale, use this as an excuse to try a 200% scale Crawling Pumpkin 👻

Print Settings

• Keep the faces flat on the build plate (faces looking up) to avoid needing supports
• Layer Height: 0.15mm recommended at original size, 0.2mm+ for larger scales
• Perimeter Generator: Classic
• Rafts: 2 layers, .15mm contact distance
• XY Size Compensation: -.1mm (may need to drop to -.15mm on some printers)