BẢN CẬP NHẬT! Đế V2 - Setup Blocks cho dụng cụ làm mộc (hệ inch)

By drofmij

Downloads: 1,075
Likes: 164
Views: 4,716
Remixes: 0
Comments: 0

Download all (.zip)· 16 files · 7.1 MB· 7.1 MB

Files 16 7.1 MB

V2_setup_blocks_base_1772716002.stlSTL · 44.6 KB
setup_blocks_full_set_1772716002.stlSTL · 404.3 KB
setup_blocks_1_2_in_1772716004.stlSTL · 25.8 KB
setup_blocks_3_8th_1772716005.stlSTL · 50.2 KB
setup_blocks_1_4th_1772716006.stlSTL · 20.7 KB
setup_blocks_7_8th_1772716007.stlSTL · 35.1 KB

Make a variant with AI

Build another version of this model.

Open Studio

Details

Model ID: #238512
Category: DIY
Published: 03/05/2026
License: Creative Commons — Attribution
Tags: block
setup
measurement

Show more tags Show fewer tags

Description

****************
If you download 💾 or collect 🗄 please hit the LIKE 👍 button. 😀

If you print 🖨 it post a picture 📷 / MAKE! 😄 Let me know how it works for you.❔ 🙂

Don't forget you earn Prusameters🧵 when you post a MAKE!
****************

##########

2026-02-16 - I updated the base to be easier to print and easier to use. I tried a few different designs before settling on the "X" shaped slots for each block. Blocks have not been updated, only the base. I printed this base at 100% and the blocks fit well from my Prusa Mini.

I printed with 0.2 layer height, no supports needed and they were within a few hundredths of a millimeter of the correct size with my calipers.

##########

This is a simple set of setup blocks that I created to use with table saw, router, and other woodworking power tools.

I printed these on a Prusa Mini with PLA and measured with digital calipers. Accuracy was +- 1/128th inch measured with calipers. I found this to be close enough for my woodworking projects.

I printed the base at 101% size which was a good amount of clearance to click the blocks into the base for storage when I printed.

I filled in the info on each block with a fine point marker.