
Giá đỡ treo tường cho AMS Bambu Lab nguyên bản
- Downloads
- 416
- Likes
- 64
- Views
- 2,440
- Remixes
- 1
- Comments
- 10
Files 4 594.1 KB
- AMS_Wall_Mount_Original_Model_-_Right_1766231142.stlSTL · 260.3 KB
- AMS_Wall_Mount_Original_Model_-_Left_1766231143.stlSTL · 260.3 KB
- AMS_Wall_Mount_Original_Model_-_Right_Test_Block_1766231145.stlSTL · 36.7 KB
- AMS_Wall_Mount_Original_Model_-_Left_Test_Block_1766231145.stlSTL · 36.7 KB
Make a variant with AI
Build another version of this model.
Remix versions 1
See all 1 remixDetails
- Model ID
- #23835
- Category
- Máy In 3D
- Published
Description
This is a remix of the Wall mounts for Bambu Lab AMS model byCory Charltonwhich is a remix of the Wallmount for Bambu AMSmodel created by StefanWoX. This remix only adjusts the spacing of the mounting blocks to fit the original AMS design. There are both right and left test blocks in the files section.
The following is copied from Cory's description:
The AMS unit will sit ~63mm from the wall with these mounts which will allow you to fully open the lid.
Testing
I've included a test model so you can quickly print out a low quality piece to ensure the key parts will fit with your AMS unit. The test piece should fit flush into the last three rectangular slots. The end of the test piece will roughly be flush with the back of the AMS unit.
Printing tips
I opted to use PETG for my mounts with the following settings:
- 0.2mm layer height
- 6 wall loops
- 5 top and bottom layers
- 30% gyroid infill
- Tree supports for the screw holes (optional but will keep them round)
Print spec
- Formats
- stl
- Model files
- 4
- Total size
- 594.1 KB
- Largest file
- 260.3 KB
10 comments
You may also like 12 models
See all-

-

-

-
New -

-
New -

-

-

-

-

-


