Giá đỡ kẹp taplo ScanGauge II (Dash Mounting Bracket)

A simple mounting bracket that clamps onto the ScanGauge II with a 10 degree angle (this can be modified in the attached .f3d file) to better angle the screen towards the driver when mounted on a declined surface on the dash like the steering column.

The clamp has a little notch that slots into the rear RJ45 port to secure and prevent the ScanGauge from sliding sideways so this will cover the rear port.

The base has an indent for a 400mm x 250mm piece of mounting tape, I recommend using Scotch 2.5cm x 1.5m Extreme Double Sided Mounting Tape and cut a length of 400mm for a perfect fit. Make sure to clean the mounting surface in your vehicle thoroughly with something like Isopropyl Alcohol before mounting to ensure good adhesion.

Make sure to print on the edge with the notch so you don't need to use any supports.