
Móc/Kẹp máng xối tham số cho đèn Giáng Sinh (Parametric Gutter Hook/Clip)
- Downloads
- 281
- Likes
- 26
- Views
- 1,182
- Remixes
- 0
- Comments
- 0
Files 3 170 KB
- gutter-hook_thin_1772623725.stlSTL · 78.8 KB
- gutter-hook_thick_1772623726.stlSTL · 90.5 KB
- gutter-hook_1772623726.scadSCAD · 754 B
Make a variant with AI
Build another version of this model.
Details
- Model ID
- #235282
- Category
- Đồ Gia Dụng
- Published
Description
This is a minimalistic and effective gutter hook. I did not find any other model that fitted quite right, were using hours to print, or could be tuned, so I quickly made one in OpenSCAD.
The ones shown on the picture are printed using Extrudr PETG. They have width and diameter of 2mm and are very sturdy for the purpose. If you don't use PETG, you might want to tune the thickness a bit.
I've rendered two different variants of the model - a thin and big one. The small one is shown in the picture and can hold about 2 strains of wire. The bigger one's recommended if you need it to be more sturdy, or have bigger wire diameters.
Need different diameters? Want a bigger/smaller opening for the wires? Want a thicker model?
→ As always with my models - the source file is in the downloads. Use the OpenSCAD model to tune it your way!
Print spec
- Formats
- scadstl
- Model files
- 3
- Total size
- 170 KB
- Largest file
- 90.5 KB
0 comments
You may also like 12 models
See all-

-

-

-
New -

-

-

-

-

-

-
New -


