
SV06 Plus Fan Duct Regular Volcano (Ống gió quạt cho Volcano nozzle)
- Downloads
- 669
- Likes
- 102
- Views
- 6,251
- Remixes
- 0
- Comments
- 0
Files 1 38.2 MB
- SV06_Plus_Volcano_Duct_v1.2_1772577396.stlSTL · 38.2 MB
Make a variant with AI
Build another version of this model.
Details
- Model ID
- #234624
- Category
- Máy In 3D
- Published
Description
…Please at least be sure to hit like & post a make, I'd love to see your prints!
Use volcano nozzles in your sv06 plus.
DONT LEAVE A BAD REVIEW BECAUSE YOU DID A BAD PRINT! Like the single reviewer here! That's just not cool.
It’s basically just meant to be a quick & simple no-frills stock unit replacement to allow you to install & use regular volcano nozzles. It’s meant to just get you printing with the new nozzle type, please don’t expect upgrade miracles.
Print standing upright on its flat nozzle-side face. Use petg 0.2-0.3mm layer height. No supports required.
Once printed. Replace stock fan duct
Add volcano nozzle, fit silicone sock after slightly trimming back the height of the nozzle opening - not too much!!
You will need to adjust the probe in the holder upwards to set your new Z offset correctly - check YouTube for setting inductive probe height.
Print spec
- Formats
- stl
- Model files
- 1
- Total size
- 38.2 MB
- Largest file
- 38.2 MB
0 comments
You may also like 12 models
See all-
New -

-

-

-

-
New -

-

-
New -
New -

-


