
Ngàm gắn camera DJI O4 Lite cho Apex 2 inch
- Downloads
- 115
- Likes
- 15
- Views
- 891
- Remixes
- 0
- Comments
- 0
Files 1 29.2 KB
- Apex2_-_04_Mount_1772565757.3mf3MF · 29.2 KB
Make a variant with AI
Build another version of this model.
Details
- Model ID
- #234416
- Category
- DIY
- Published
Description
You will need to mirror this to print both sides.
The camera mounting plates are replaced as are the front stand offs due to the camera being too wide. The small tabs that lock into the frame will need filing until you are happy with the fit. I printed these in ABS and filing all 4 tabs took just a few seconds. Camera angle is adjustable from 25-35 degrees, I couldn't make it any less without there being too little material to make the mount strong enough between the bottom screw and frame.
I've flown a few packs with it and I'm happy with the result, no frame or props in view, the quad is only a couple of grams heavier with the O4 lite.
Category: Other
Print spec
- Formats
- 3mf
- Model files
- 1
- Total size
- 29.2 KB
- Largest file
- 29.2 KB
0 comments
You may also like 12 models
See all-

-

-

-

-
New -

-

-

-

-

-

-
New

