Kẹp Khóa Bịch Snack (20cm)

I’ve been advised by my partner that large bags of snacks are not a single portion. I know, it is a revelation, who knew?

This is a print in place 200mm Snack bag clamp for deployment if you have been caught and there is no escape. An air tight seal will only be achieved on the inner latch point. the outer latch part is intended primarily as a latch knob. Tolerance for Snack-Packet material is 0.4mm

UPDATED (13-01-25): Now V2. I am aware from a friend that he has had probs printing this on his Ender, although it worked fine on my Mk4. Now lighter and more compact. Performance un-changed (same 20cm capacity and strength). 20mm tolerance from edge of build plate to aid bed adhesion. Significantly less material, now prints in 2.5h rather than original 4.5h. Overhang tolerances relaxed to 30 degrees from 20 to reduce/eliminate overhang stringing. 

Includes PiP hinge. When easing/releasing hinge hold close to the hinge pivot point And work both ways slowly increasing pressure.

Printed in PETG since this is both food safe and waterproof. STL plus Mk4 BgCode. Design gives PiP tolerances of 0.4mm (V) 0.4mm (H). BgCode gives you 50% gyroid fill and a 0.15mm layer.