(FreeCAD parametric) Lược fade cho râu (beard comb)

Fadeing combs for hair don't work for beards. So i made this parametic FreeCAD model which i like to share. I used FreeCAD Version 1.0.0RC2.38806 (Git) and VarSet for parameters instead of a (classic) spreadsheet. 

The STLs have a width of 50mm and I have set the properties for width read only, because i didn't test it properly so don't expect it to work.

Keep in mind, if you need a left handed version of the “40mm fade from 1 to 9 beard comb.stl” you can use the mirror function in your slicer. 

Print instructions:

• Use a 0.4 Nozzel (lamellas are 1.2mm)
• Try not to use a brim, instead make sure you have a good bed adhasion
• 3 Walls
• Layer heigth 0.16mm or lower
• No supports

I printed my in PLA and one in PETG. 

Update 19.01.25:

• Bugfix: Guard was not calculated correct