Poop Box cho Bambu Lab A1 Mini với Quick Disconnect

I was looking for a poop box for the A1 mini but couldn't find any design with magnets so I designed my own. Also, it serves as a stop (or a good reference point) if you're putting the printer against a side wall. The receiver has a slight angle that fits the side of the printer.

You'll need:

• Double Sided Tape.
• Two 4 x 2 mm magnets.
• Two 6 x 2 mm magnets.
• Recommended: rubber pads for the box.
   

Printing:

• No supports needed.
• It's 178 mm long to fit the A1 Mini build plate.

*You can test your printer capabilities with my QuBenchy - 3D Printing Torture Test Cube:

Assembly: 

• Glue the magnets into place (careful with the polarity)!
• Optional: add the rubber pads to the box.
• Apply the double sided tape to side plate.
• Join both parts using the magnets and place them next to the printer.
• Align the pieces with the printer (in height and depth), and push to stick the side plate to the printer.
• Done!

Feedback is welcome. Cheers!

------------------------------------

Rendered in Blender, using Blender Boom's Desk Scene and @Az3Dip's Ender 3.