Zero Resistant PTFE Coupler M10

Working on a different Project, i needed a ptfe coupler. But they all had the same issue. They had no good interface without resistant. So i thought about, how to solve the problem and found the solution.
I present you, the best “Zero Resistant coupler”

The difference is that that the 2 Ptfe Tubes are aligned, and that the receiving PTFE Tube has an angled entrance.
Also the PTFE Coupler has a Window to check if the Tubes are connected.
Only angle the Receiving PTFE Tube, else the resistance will be higher.

There is a arrow imprinted in the Design to show the direction in which the Filament will be moving. Is also shows print orientation ;-)

The Coupler used are these:
https://www.amazon.de/gp/product/B0CS3NTBXL/ref=ppx_yo_dt_b_search_asin_title?ie=UTF8&psc=1

Have fun, with another of my designs!

You can support me via a tip clicking on the link: 

Tip me on KO-FI by klicking here:

                                                      https://ko-fi.com/surfalex2000