Đáy case Corne Cherry V4 nghiêng 6 độ (Bottom)

This is an addition to the model created by @alko (https://www.printables.com/model/1297216-corne-choccherry-v4-case). This adds the inclined bottom for the Cherry-style board, since the original model only contained an inclined bottom of 6 degrees for the Choc-style board. This is the same 6-degree inclined bottom, but for the Cherry-style board.

Materials used for assembly:

• 8x threaded insert (M2.5x4x3.5)

• 8x bolt with flat head (M2.5x8 → M2.5x10 is recommended though)

• 8x 8mm rubber bump pads to prevent sliding

Printed using PETG at 15% infill at normal quality settings, though PLA or other materials should work fine as well. Printing at a higher infill presumably makes the keyboard quieter, but I haven't tested this.