
Chân đế cho bảng peg IKEA Skådis (đứng độc lập)
- Downloads
- 2
- Likes
- 1
- Views
- 57
- Remixes
- 0
- Comments
- 0
Files 1 3.1 MB
- Sk_dis_stand_1772151416.objOBJ · 3.1 MB
Make a variant with AI
Build another version of this model.
Details
- Model ID
- #227790
- Category
- DIY
- Published
Description
These stands are 12.5 cm long, with 8 cm in the front to give the board plenty of stability, so it doesn't tip over. The bottom surface is flat so you can use foam mounting tape to secure them further.
The screws are not strictly necessary as the Skådis board fits snugly into the slot, though you can secure them with the original IKEA screws that came with the board. The holes for the screws are slightly undersized so the screws taps into the plastic as well.
Print details:
I printed mine with Prusament ASA at 0.2 mm layer height, 4 perimeters / top / bottom layers, and 15% gyroid infill. It takes ~ 45 g filament and 2.5 h printing time for a pair of two stands.
I recommend printing the stand on its side (as shown in the slicer screenshot) so the curve on the top surface looks smooth. Supports are optional, but don't add them inside the small holes as that would affect the dimensional accuracy.
Print spec
- Formats
- obj
- Model files
- 1
- Total size
- 3.1 MB
- Largest file
- 3.1 MB
0 comments
You may also like 12 models
See all-

-

-

-

-

-

-
New -

-

-

-

-


