Túi đựng băng đạn AR-15 / M4 (AR-15 / M4 mag pouch)

Since I didn’t find any design that quite did what I wanted, I made this.

In parallel, I designed the universal Molle clip which is used to mount the pouch. It can be found stand alone here, should you want to use it for your own designs.

Features

• decently high walls, not ultra low height pouches

• strong magazine retention

• easy to mount & remove from Molle

• decent flaring without being at risk of breaking

Hardware

In terms of hardware, each pouch will require:

• 4x heat set insert M4 , 4mm height

• 4x M4x6 low profile screw (head height no more than 2.3mm)

• 4x M4 washer

• 65cm of 3mm paracord

• 2x assembled Molle Clip

That’s indeed quite a lot and I’m working on a completely different design which will be a single print and use very little hardware. That’s still just a concept at the moment though.

The files for the Molle clip are no longer included to insure that you will always get the most up to date version from the clip's page.

For assembly, refer to the picture included.

If you have any feedback on the pouch, please leave it below. I’ll run them myself but any feedback will be helpful for a potential, future revision. The pouch was designed with airsoft in mind as has not been tested with real steel magazines. That said, it should work fine and I'd be happy if somebody tried it.

Feel free to write me a message or leave a comment if you have an issue or questios